Hallo Trieben,
Nicht dass ich wüsste. Ich gebe das aber gerne weiter; eventuell lässt sich ein Alpha-Wert einfach nachrüsten.
Freundliche Grüße,
Frederik
Hallo,
gibt es eine Möglichkeit, die Textur eines Gebäude transparent(er) zu gestalten?
Für Gebäude mit komplexen Dachaufbauten könnten wir so relativ zügig eine erste Grobauslegung erstellen, indem wir ein "gläsernes" Gebäude auf einen Kartenausschnitt stellen.
Vielen Dank vorab
Leo Triebel
Hi
I don't know how to draw the half-hipped roof in a right way .. I always face that each Attic Storey has different inclination.
May you please tell me the right way to draw it?
Hi Niklas,
thanks for the project file.
I now know how the yield reduction can be influenced, that it can be slightly negative in marginal cases. Two factors contribute to this: firstly, that the outlet air pipe is relatively small and secondly, that it is located on a roof overhang.
To avoid this behavior, you could change the roof so that it no longer has any overhangs and is longer by the corresponding length. The reduction in yield should then be 0.1 % instead of -0.1 %.
Since it only occurs at very low values of yield reduction (if the outlet air pipe is slightly higher, the yield reduction behaves as expected) and the simulation is almost unaffected by this, the bug will probably be prioritized low. Nevertheless, many thanks for the report and I will send it to the developer for this area.
I also asked whether PV*SOL calculates a yield reduction due to shading if the shadow only falls on the edge of a module (i.e. in an area without photocells). The answer is no. Only the area minus the module edge and module frame is used to calculate the yield.
Kind regards and good luck with your project!
Mikio
Hätte mehrere Dinge:
Für Polygone das Maß händisch anpassen lassen.
Dachüberstand zwei Dachseiten auswählen zu können und nicht nur eine.
Maßstabsbalken bei Kartenausschnitt kleiner bzw. genauer gestalten.